The third oxygen atom of ozone makes it extremely reactive. This atom readily attaches itself to other odor molecules. When contaminants such as odors, bacteria or viruses make contact with ozone, their chemical structure is changed to less odorous compounds. As more ozone attacks the remaining compounds, the odor is eventually destroyed. This process is called oxidation. Ozone essentially reverts back to oxygen after it is used. This makes it a very environmentally friendly oxidant.

There are basically two methods of producing ozone…ultra-violet and corona discharge. Corona discharge creates ozone by applying high voltage to a metallic grid sandwiched between two dielectrics. The high voltage passes through the dielectric to a grounded screen/plate and in the process, creates ozone from oxygen present in the chamber. Ultra-violet (UV) light creates ozone when a wavelength at 254 nm (nanometers) hits an oxygen atom. Both processes split oxygen molecules into single oxygen atoms (O). These atoms combine with another oxygen molecule (O2) to form ozone (O3).

As soon as ozone is formed in the generator and dispersed in a room, it will start to revert back to oxygen. This step occurs by several processes including the following: Oxidation reactions with an organic material such as odors or smoke. Reactions with bacteria etc., which again consumes ozone by oxidation reactions. Additionally ozone breaks down thermally. Higher temperatures destroy ozone quicker than lower temperatures. The ozone that remains is referred to as Residual ozone. “Residual” ozone created will return to oxygen usually within 30 minutes, in amounts equal to half its level. What this means is that after each subsequent 30 minute period there would be half as much residual ozone left at the end of the period as was present at the beginning of the period. This is similar to a geometric progression of 16;8;4;2;1. In practice the half life is usually less than 30 minutes due to temperature, dust, and other contaminants in the air. Therefore, ozone, while very powerful, doesn’t last long. It does its job and then disappears back into safe oxygen.

No. If ozone is applied properly it destroys the source of the odor. Treatment times may vary depending on the strength of the odor but 98% of ozone treatments are successful. In the case of mildew the odor will return if you are unable to get rid of the moisture that is the source of the mildew.

The right level is when all the generated ozone is being consumed. This only applies to continuous ozone use in occupied environments not for shock treating. However, this is difficult to attain because it becomes a balancing act. Initially the machine’s output is set high to get rid of the problem odor as quickly as possible. As this is being accomplished less ozone is required for the diminishing odor etc., thereby leaving some residual ozone in the air. If the machine output is not turned down, then more residual ozone will remain. If a strong smell of ozone is noticed, then there is more ozone present than is required. Simply decrease the rheostat (output level control). With ozone, MORE IS NOT CONSIDERED BETTER! One must be careful when using ozone in a occupied environment. NOTE: It is not necessary that ozone be detected by humans for it to be effective. Ozone can work even when humans are not able to smell it.

Ozone was discovered almost a two centuries ago, so a great deal is known about it. Several regulatory agencies, including the Occupational Safety and Health Administration (OSHA), have stipulated that the safe allowable level of residual is 0.1 ppm (parts per million). Note that this permissible level is for continuous exposure throughout an entire 8 hour day. The temporary affects of such a low exposure would range from headaches, to sore throats, irritation in the eyes, and nose. No long term effects have ever been documented from ozone exposure.

• Ambient air is pulled into the ozone generator
• A filter prevents dust and insects from lodging in the corona cell
• A fan accelerates air through the unit for ozone creation
• A high voltage corona mechanism converts the oxygen to ozone
• A protective stainless steal grill ensures that people cannot touch the corona cell while in operation
• Powerful ozone exits the machine where it can oxidize odors, smoke, and other harmful contaminants. The entire process takes less than 1 second!

Ozone kills bacteria by destroying the cell wall of the bacteria. Once the cell wall is destroyed, the bacteria will be unable to survive.